Gooeylight Generation Ⅱ control system provides an easier installation method, only need to connect the wiring positive/negative lead to the bike battery and mount the switch on the handlebar. You will start an interesting and safe riding trip with all the lights. The Generation Ⅱ control will automatically detect the bike's battery status and provide low voltage protection. The memory function records your lighting set of last riding to save your preparation time before riding.

Only through the switch controller, riders can adjust the brightness from 5-100%, adjust the color temperature from 3000K to 6500K and switch over two groups lights freely. Achieving 100% brightness in seconds and 100% continuous flashing easily.

Under the intelligent mode with smart light sensor, only DRL allowed to be turned on during the day. But there is no doubt, the lights will turn on automatically when riders cross the dark tunnels. Such a powerful switch controller!

If you prefer to let the lights work with bike's original high beam/horn/turn signal buttons, it means lights achieve 100% brightness when you turn on your high beam and flash to full when you sound your horn,flash at the same frequency with your turn signal lights. We have the 5-pins(ACC/High beam/Horn/Left turn/Right turn) input cable as accessory for selection.

What is the main difference between G-Ⅰ and G-Ⅱ control system?

Control system = Control wiring harness+Switch controller

1. Installation method. G-Ⅱ has two options, you can choose to only connect the positive and negative lead to bike battery, then 100% brightness achieving and flashing only can be controlled by the switch controller. Adding an extra 5-pins input wire (Acc/high beam/horn/right turn/left turn) can make the lights work with bike's original lights and horns. G-Ⅰ only has one option, the wiring harness comes with 3-pins input wire (Acc/high beam/horn), that is the necessary component of the wiring harness, not an option.

2. The number of output connectors. G-Ⅱ standard control wiring harness comes with 2 output connectors which means it can work with 2 pods. We have universal Y wire to expend more pods. If you want to use 4 pods on one G-Ⅱ control system, we will provide extra 2pcs Y wires. For  G-Ⅰ control wiring harness, 4 connectors is the standard configuration.

3. Hardware. G-Ⅰ hardware distributed in switch controller, light pods, metal control box on the wiring harness. G-Ⅱ control part only in switch and light pods which reduces the failure rate.